|
EASY-BUS-display and monitoring device for 9
channels
- The EB 2000 MC is able to display and monitor up to 9 sensor
modules or loggers.
- The EB 2000 MC automatically detects the number and type of
sensor modules connected (e.g. temperature, humidity, pressure sensors
etc.). Neither sensor adjustment nor re-configuration are required.
The display will always be in the correct dimension.
- Sensor module and logger supply as well as data transfer are
carried out via one single 2-wire line. No additional voltage supply
for sensor modules required.
- The EB 2000 MC monitors all sensor and logger functions as well
as cable and sensor damage etc. and will pass an alarm message in case
of fault.
- The EB 2000 MC is equiped with 2 volt-free relay outputs (make
contact) for min./max. alarm
- The EB 2000 MC is equipped with a min./max. value memory for 9
channels.
- Its standard RS 232-interface ensures easy configuration.
- The EB 2000 MC can be used as a level converter RS 232 - EASYBUS
so that all EASYLOGs connected can be read via the EB 2000 MC.
(Software required: GSOFT 40K).
|
 |
The EB 2000 MC device - cost savings in all areas!
- Short installation time - only one 2-pin line.
- Minimum material requirement - only one display and monitoring
device for up to 9 sensor modules.
- Minimum time requirement for planning and commissioning - automatic
sensor module detection, expandable for up to 9 sensor modules of any type
whatsoever.
|
 |
Advantages:
- Remote control and monitoring e.g. in your office of up to 9
rooms, (use 2 x EB 2000 MC for more rooms)
- Both current and min. and max. values will be stored and are
accessible for each channel.
- Alarm monitoring for any sensor module / logger by means of the
EB 2000 MC.
- Min./Max. alarm can be programmed individually for each sensor
module / logger.
- remote read out possible for each logger connected.
|
|
EB 2000 MC
|
|
Meas. range: -1999 to +9999 digit
Resolution: automatic detection of
resolution of connected sensor modules. Automatic positioning of decimal point.
Accuracy: depending on sensor module used.
The EBS 2000 MC transfers this value digitally without any additional fault.
Sensor modules: (not included in scope
of supply)
all intelligent EASYBUS sensor modules as well as EASYLOG
(max. 9) can be connected.
2-wire connection inring-, tree- or star type. No polarity.
Sensor supply: via EB
2000 MC.
Fault messages: sensor damage, sensor
short circuit, values above/below permissible area.
Self-diagnosis: const. monitoring to
ensure trouble-free function.
Interface: RS232 for easy configuration,
or as level converter RS232 - EASY-BUS.
Min-/Max-value memory: for up to 9
different sensor modules, selectable via front side keyboard.
Min-/Max-Alarm: 2 volt-free relays (make
contact), 10 A (ohmic load), 250 V, 50/60 Hz, for min./max alarm programmable
via front side button or RS 232 - interface. Alarm can be deleted automatically
or acknowledged (whichever, can be set manually).
Alarm delay: from 0 to 9999 minutes, can
be set individually for each channel
Display: 4-digit, red, 13mm high LED-display.16
additional LEDs for display and monitoring functions.
Front: Transparent membrane keyboard IP
65. Sealing for housing for installation according to IP 65 will have to be
ordered separately.
Housing: Standard rack-type housing 48 x 96 x
100 mm (H x W x D).
Panel cutout: 43 x 90.5 mm (H x W)
Connection terminals: screw-type/plug-in
terminals
Nominal temperature: 25°C
Ambient temperature: 0 to 50°C (permissible
ambient temperature)
Power supply: 230V AC 50/60Hz (standard)
Power consumption: approx. 3,5 VA
Options (against upcharge)
|
Please specify on order!
Power supply: 12V AC, 24V AC or
115V AC 50/60Hz (others upon request)
EASYBUS-display and supervision device, incl. level converter PC-EASYBUS - cost savings in all areas!
- Short installation time
- Minimum material requirement
- Minimum time requirement for plannig and commissioning
Please order following options and accessories separately:
- VAC: other power supply
- GGD4896 (additional sealing for panel
mounting acc. to IP 65)
- GRS 01/9 interface-Adapter RS232
(adapter cable to 9-pin PC-interface, one adapter 9/25-pin
for connection to the 25-pin PC-interface incl. in scope of supply)
- EBSK01 (Connection 1m cable for EASY-LOG,
EBN, ...)
- EBSK03 (Connection 3m cable for EASY-LOG,
EBN, ...)
- VSL2P (Twisted special cable for
EASY-BUS system, cross section: 2 x 0,75 mm2)
- AKL1P (special-branch terminal for
connection to VSL2P)
 = data sheet as *.pdf
= instruction manual as *.pdf
 deutsche Beschreibung
Price of the basic article, German V.A.T. incl
:
EUR
181.50
The net price of the basic article EB 2000 MC
is:
EUR
152.52
|
