pressure measuring device GMH 3111 with logger function, analog output
0-1V, 1,000 measurements/sec., digital sensor adjustment, also possible with ex
protection - Greisinger electronic -
hand-held pressure measuring device to
set standards!
one device for any measuring
range (2.5 mbar to 400 bar)
1 device for:
over pressure
under pressure
pressure difference
absolute pressure
air pressure/barometer
vacuum
device is bus-compatible:
up to 5 devices connectable to a PC-interface
1 device for pressure of
relative pressure
mbar: 2.500 / 25.00 / 350.0 / 2000 / 3500
bar: 10.00
pressure difference
mbar: 2.500 / 25.00 / 350.0 / 2000 / 3500
bar: 10.00
absolute pressure
mbar: 1000 / 1300 / 2000 / 3500 / 7000
bar: 7.00 / 35.00 / 70.0 / 160.0 / 250.0 / 400.0
GMH3111 (device without sensor)
GMH3111-ex (device without sensor)
specification:
max. display range:
-19999 to +19999 digits
measuring range/overload/resolution:
depends on probe connected
measuring cycle:
4 measurements / sec.
pressure units:
mbar, bar, Pa, kPa, MPa, mmHg,
PSI and m can be selected
accuracy:
(device) (at nominal temperature = 25°C) ±0.1 %FS + 1 digit
probe connection:
6-pin screened lockable Mini-DIN-sockets for GMSD-sensors
automatic probe detection and corresponding adjustment of measuring range
display:
two 4 1/2-digit LCD displays
operating elements:
6
push buttons for on/off, selection of pressure units, min/max
value memory,
hold function, tare and/or zero compensation for the relevant probe
working
temperature:
GMH 3111: -25°C
to +50°C;
GMH 3111-EX: -10°C to +50°C
relative humidity:
0 to 95% r.h.
Interface:
serial/USV interface for direct connection to RS232
or USB interface of a PC
via interface converter USB 3100 or GRS 3100, GRS3105
tare function:
display value and the min/max values memorized can
be set to zero
sensor
adjustment:
digital offset
and scale input
hold function:
by pressing a
button the current measuring value will be memorized
Min-/Max value memory:
memorizing of max and min values
power
supply:
9V-battery, d.c. connector
suitable 9V-battery type IEC 6F22 (in scope of supply),
d.c. connector for external 10.5-12V direct voltage supply (suitable
power supply: GNG 10/3000)
power
consumption:
max. 1.6 mA (external probe
incl.)
battery changing display:
'bAt'
power-Off-function:
1 to 120 min (can also
be deactivated)
housing
dimensions:
142 x 71 x 26 mm
impact-resistant ABS plastic housing, front side IP65,
integrated pop-up clip for table top or suspended use (not at GMH
3111-EX)
weight:
approx. 155 g, Ex-construction approx. 190 g (bag incl.)
REMARK:
The selection of various pressure units
is possible only,
if the total measuring range of this unit can be shown on the display.
EX qualification:
Ex qualification:
EX II 2 G EEx ib IIC T4
ref. document
ZELM 03 ATEX 0136 X
standards:
the device meets the standards for
electric equipment in explosion endangered
areas according to EN 50 014: 1997+A1+A2, EN 50 020: 1994
probe:
All GMSD sensors with option "Ex type"
can be used.
interface:
suitable interface adapter are USB 3100, GRS 3100
and GRS 3105
(the operation of the interface is not allowed within the Ex area!)
working temperature:
-10°C to +50°C
power supply
9V-Battery, type IEC 6F22
(the device hasn't got a dc connector for external power supply!)
scope of supply:
device with associated leather case
Only ONE portable device for a all kinds of pressure and for any measurement ranges
Lose device without sensors and accessories
Follower of GMH 3110
Please order the following accessories separately:
Please order furthermore separately:
= data sheet as *.pdf
= instruction manual as *.pdf
deutsche Beschreibung
Price of the basic article, German V.A.T. incl
:
EUR
163.00
The net price of the basic article GMH 3111
is:
EUR
136.97