|
DIGITAL-FINE MANOMETER
for over / under pressure and pressure difference
- Compact design (sens. incl. in electronics housing) with
sturdy metal connection pin
- Interface
- Device suitable for connection to bus system (connection of up to 5
devices to
one PC interface
- Min-/Max. memory
- Hold function
- Tare function/zero point offset
- Pressure units selectable
- Ex-protection upon request
|
|
GMH 3160-01
-100 to 2500 Pa (-2500... +2500 Pa)
Device ready for operation incl. sensor battery or d.c. operation
Specification
:
Measuring range: -100 to 2500 Pa
(-2500 ... +2500 Pa)
Overload: max. 100 mbar
Resolution: 1 Pa 0.01 mbar)
Pressure units: mbar, bar, Pa, kPa, mmHg, PSI, m,
can be chosen by
pressing a button
Accuracy: (typ. values)
±0.3%FS (hysteresis and linearity)
±0.4%FS (temperature influence from 0-50°C)
Sensor: piezo-resistive relative pressure sensor.
Suitable for air and non-corrosive,
non-ionizing gases and liquids.
Sensor-connection: 2 metal connection
pins, made of brass, nickel plated, pressure tubes 6x1 mm
(4 mm inner diameter) can be
connected to the front side of the device
Display: 2 four-digit LCD displays for nominal
value (12.4mm high)
and for min./max. values,
hold-function, etc. (7 mm high)
Another 11 functional arrows for
pressure unit selection and tare etc.
Nominal temperature: 25°C
Working temperature: 0 to +50°C
Relative humidity: 0 to +95% r.h. (not
condensing)
Storage temperature: -20 to +70°C
Interface: serial interface can be
directly connected to RS2322 interface of a PC via interface adapter GRS 3100
Min-/Max-value memory: both max. and min. values will be memorized.
Hold function: Upon pressing a button the nominal value will be
memorized.
Tare function: Both the value displayed and the
min./max values will be set
to zero by means of the tare key. No
pressure: zero point offset.
Push buttons: 6 membrane keys for ON /OFF-switch, selection of
pressure units,
min- and max-value memory,
hold-function, tare and zero point compensation
Power supply: 9V battery, type IEC 6F22 (included),
as well as additional mains adapter (internal
pin diameter 1.9 mm) for
external 10-12 V direct voltage
supply. (suitable power supply: GNG 10/3000)
Power consumption: approx. 3mA
Low battery warning: 'bAt'
Power-Off-Function: Device will be
automatically switched off if no key is pressed /
no interface communication takes
place for the time of the power-off delay.
The power-off delay can be set to
values between 1 and 120 min., or completely deactivated.
Dimensions: (sensor connection point not
included) 142 x 71 x 26 mm (H x W x D)
sensor pin: approx. 11 mm
protruding at front side of device.
Impact resistant ABS plastic housing,
membrane keyboard, transp. panel.
Front side IP65, integrated pop-up
clip for table top or suspended use.
Weight: approx. 160 g
DIGITAL-FINE MANOMETER for over / under pressure and pressure difference, measuring range from -100 to 2500 Pa, completely with sensor
direct follower of GMH 3160-01
Please order following options separately:
Please order furthermore separately:
also available as GMH 3181-01 with additional functions (logging, alarm, controlling)
 = data sheet as *.pdf
= instruction manual as *.pdf
 deutsche Beschreibung
Price of the basic article, German V.A.T. incl
:
EUR
293.00
The net price of the basic article GMH 3161-01
is:
EUR
246.22
|
